CSA Group Information technology - Radio frequency identification for item management - Part 3: Parameters for air interface communications at 13,56 MHz (Adopted ISO/IEC 18000-3:2010, third edition, 2010-11-15)

Preface Standards development within the Information Technology sector is harmonized with international standards development. Through the CSA Technical Committee on Information Technology (TCIT), Canadians serve as the Canadian Advisory Committee (CAC) on ISO/IEC Joint Technical Committee 1 on Information Technology (ISO/IEC JTC1) for the Standards Council of Canada (SCC), the ISO member body for Canada and sponsor of the Canadian National Committee of the IEC. Also, as a member of the International Telecommunication Union (ITU), Canada participates in the International Telegraph and Telephone Consultative Committee (ITU-T). This Standard supersedes CAN/CSA-ISO/IEC 18000-3-09 (adoption of ISO/IEC 18000-3:2008, second edition, 2008-09-01). At the time of publication, ISO/IEC 18000-3:2010 is available from ISO and IEC in English only. CSA will publish the French version when it becomes available from ISO and IEC. Scope This part of ISO/IEC 18000 provides physical layer, collision management system and protocol values for RFID systems for item identification operating at 13,56 MHz in accordance with the requirements of ISO/IEC 18000-1. This part of ISO/IEC 18000 provides definitions for systems for each MODE determined in Clause 6 below. This part of ISO/IEC 18000 defines three non-interfering MODES.  The MODES are not interoperable.  The MODES, whilst not interoperable, are non-interfering.