CSA Group CSA N290.15:19 (reaffirmed 2024) Requirements for the safe operating envelope of nuclear power plants

Preface

This is the second edition of CSA N290.15, Requirements for the safe operating envelope of nuclear power plants. It supersedes the previous edition published in 2010.

The CSA N-Series Standards provide an interlinked set of requirements for the management of nuclear facilities and activities. CSA N286 provides overall direction to management to develop and implement sound management practices and controls, while the other CSA Group nuclear Standards provide technical requirements and guidance that support the management system. This Standard works in harmony with CSA N286 and does not duplicate the generic requirements of CSA N286; however, it may provide more specific direction for those requirements.

Users of this Standard are reminded that the design, manufacture, construction, commissioning, operation, and decommissioning of nuclear facilities in Canada are subject to the provisions of the

Nuclear Safety and Control Act and its supporting Regulations.

This Standard has been prepared by the Subcommittee on Requirements for Safe Operating Envelope of

Nuclear Power Plants, under the jurisdiction of the Technical Committee on Reactor Safety and Risk Management and the Strategic Steering Committee on Nuclear Standards, and has been formally approved by the Technical Committee.

Notes:

1) Use of the singular does not exclude the plural (and vice versa) when the sense allows.

2) Although the intended primary application of this Standard is stated in its Scope, it is important to note that it remains the responsibility of the users of the Standard to judge its suitability for their particular purpose.

3) This Standard was developed by consensus, which is defined by CSA Policy governing standardization — Code of good practice for standardization as “substantial agreement. Consensus implies much more than a simple majority, but not necessarily unanimity”. It is consistent with this definition that a member may be included in the Technical Committee list and yet not be in full agreement with all clauses of this Standard.

4) To submit a request for interpretation of this Standard, please send the following information to [email protected] and include “Request for interpretation” in the subject line:

a) define the problem, making reference to the specific clause, and, where appropriate, include an illustrative sketch;

b) provide an explanation of circumstances surrounding the actual field condition; and

c) where possible, phrase the request in such a way that a specific “yes” or “no” answer will address the issue.

Committee interpretations are processed in accordance with the CSA Directives and guidelines governing standardization and are available on the Current Standards Activities page at standardsactivities.csagroup.org.

5) This Standard is subject to review within five years from the date of publication. Suggestions for its improvement will be referred to the appropriate committee. To submit a proposal for change, please send the following information to [email protected] and include “Proposal for change” in the subject line:

a) Standard designation (number);

b) relevant clause, table, and/or figure number;

c) wording of the proposed change; and

d) rationale for the change.

1 Scope

1.1

This Standard outlines a consensus approach to defining, implementing, and maintaining the SOE at NPPs. Additional guidance is provided in Annex A for operating CANDU® NPPs.

1.2

In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; “should” is used to express a recommendation or that which is advised but not required; and “may” is used to express an option or that which is permissible within the limits of the Standard.

Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.

Notes to tables and figures are considered part of the table or figure and may be written as requirements.

Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.